High-pressure pump skids
Plunger pumps for misting and fog cannon systems, with pulsation damping, relief valve and fine filtration.
Single fluid (high pressure)Nozzles get the attention, but the pump and tank decide whether they receive the pressure and flow they were selected for. We size and supply pump skids and storage for dust suppression systems.

An undersized pump shows up as weak spray at the far end of the line. An oversized one cycles on and off and wears out its seals.
Each skid is matched to the nozzle schedule and the number of zones that run together.
Plunger pumps for misting and fog cannon systems, with pulsation damping, relief valve and fine filtration.
Single fluid (high pressure)Centrifugal and multistage pumps for rain guns, sprinklers and low-pressure spray headers.
Sprinkler systemGround or elevated tanks with level control, sized so the pump never starves during a full cycle.
Water spray systemStarters, timers, level and pressure interlocks, with an option for PLC and remote operation.
Automation & controlsFlow is the sum of the nozzles in the largest zone. Pressure is what those nozzles need, plus the losses in pipe, fittings, filters and height. Tank volume is that flow multiplied by the longest run you expect between refills, with a margin. Send us the nozzle list or the area to cover and we will work through it.
Send photographs, a layout or a short description of where the dust comes from.
We review each source, the material, water and power available, and any moisture limits.
You receive a layout, equipment list and price for the system that fits.
We supply, install and commission, train your operators and stay available for service.
Send photos or a layout of the dust source. An engineer will recommend a system and send a budget price.
Misting and fog systems use high-pressure plunger pumps. Sprinklers and rain guns use centrifugal or multistage pumps. The choice follows from the nozzle type and flow.
Large enough to supply the biggest zone for its longest run with a safety margin, taking the refill rate into account. We calculate it from your layout.
Yes. Any system with fine nozzles needs filtration finer than the nozzle orifice, and hard water may need treatment to prevent scaling.
Yes. Share the nozzle count, pipe sizes and present pump details and we will recommend a matching replacement.
Send the basics and an engineer will come back with a recommendation and a budget price.