Skip to content
Chennai · Nagpur · GurugramService locationsFAQs
Dust Suppression Systems Co homeGet a quote
Components · Pumps & tanks

Dust suppression pumps and water tanks

Nozzles get the attention, but the pump and tank decide whether they receive the pressure and flow they were selected for. We size and supply pump skids and storage for dust suppression systems.

Single fluid dust suppression nozzles
PumpsHigh-pressure plunger, multistage and centrifugal
SkidsPump, motor, filters, valves, gauges and panel
TanksSized for demand, refill rate and running hours
ProtectionDry-run, low-level and pressure safeguards
The problem

What goes wrong with pumps and storage

An undersized pump shows up as weak spray at the far end of the line. An oversized one cycles on and off and wears out its seals.

  • Pressure too low at the last nozzle because pipe losses were ignored
  • Pump running dry when the tank empties
  • Blocked nozzles from unfiltered or hard water
  • Tank too small for the longest running zone
Our approach

What we supply

Each skid is matched to the nozzle schedule and the number of zones that run together.

High-pressure pump skids

Plunger pumps for misting and fog cannon systems, with pulsation damping, relief valve and fine filtration.

Single fluid (high pressure)

Sprinkler and spray pumps

Centrifugal and multistage pumps for rain guns, sprinklers and low-pressure spray headers.

Sprinkler system

Water storage tanks

Ground or elevated tanks with level control, sized so the pump never starves during a full cycle.

Water spray system

Control panels

Starters, timers, level and pressure interlocks, with an option for PLC and remote operation.

Automation & controls

Sizing basics

Flow is the sum of the nozzles in the largest zone. Pressure is what those nozzles need, plus the losses in pipe, fittings, filters and height. Tank volume is that flow multiplied by the longest run you expect between refills, with a margin. Send us the nozzle list or the area to cover and we will work through it.

How we deliver

From enquiry to a working system

01

Share the problem

Send photographs, a layout or a short description of where the dust comes from.

02

Site study

We review each source, the material, water and power available, and any moisture limits.

03

Design and quote

You receive a layout, equipment list and price for the system that fits.

04

Install and support

We supply, install and commission, train your operators and stay available for service.

Keep exploring

Related systems and applications

Ready to get started? Let’s discuss your project.

Send photos or a layout of the dust source. An engineer will recommend a system and send a budget price.

FAQ

Frequently asked questions

Have a different question? Ask our engineers.

What pump is used for dust suppression?

Misting and fog systems use high-pressure plunger pumps. Sprinklers and rain guns use centrifugal or multistage pumps. The choice follows from the nozzle type and flow.

How big should a dust suppression water tank be?

Large enough to supply the biggest zone for its longest run with a safety margin, taking the refill rate into account. We calculate it from your layout.

Do I need water filtration?

Yes. Any system with fine nozzles needs filtration finer than the nozzle orifice, and hard water may need treatment to prevent scaling.

Can you replace the pump on an existing system?

Yes. Share the nozzle count, pipe sizes and present pump details and we will recommend a matching replacement.

Get a recommendation

Tell us where the dust is. We will tell you what fits.

Send the basics and an engineer will come back with a recommendation and a budget price.

  • No-obligation budgetary proposal
  • Design matched to your material and site
  • Supply, installation and service