Skip to content
Chennai · Nagpur · GurugramService locationsFAQs
Dust Suppression Systems Co homeGet a quote
Components · Automation & controls

Automated dust suppression and control panels

A dust suppression system that runs all day wastes water and wets material that is not moving. Automation switches each zone on when dust is being generated and off when it is not.

Automated dust control system
TriggersBelt running, material present, vehicle, wind, dust level
HardwarePLC panel, solenoid valves, sensors, HMI
BenefitsLower water and air use, consistent control
OptionsRemote monitoring and alarms
The problem

The cost of manual operation

Manually operated systems depend on someone remembering to open a valve. In practice they run either too much or not at all.

  • Spray left running on an empty belt
  • System switched off after a blocked nozzle and never restarted
  • No record of when suppression ran, for audits or complaints
  • Operators exposed while walking to valves in dusty areas
Our approach

What we automate

Controls are added to new systems or retrofitted to existing ones.

Material and belt interlocks

Spray runs only when the conveyor is running and carrying material, sensed by belt-load or motion switches.

Conveyors & transfer points

Vehicle and tipping triggers

Sensors start the fog ring when a truck or wagon is in position and stop it after a set delay.

Hoppers & unloading

Weather and dust-level control

Wind speed, humidity or a particulate monitor starts yard zones when conditions call for it.

Stockpiles & stockyards

Sequenced zone control

A PLC cycles sprinkler and cannon zones so one pump covers a large area.

Sprinkler system

Monitoring and records

The panel logs run hours, zone activity, pressures and faults. That gives maintenance an early warning of blocked filters or failing pumps, and gives your environment team evidence that controls were running. Remote access lets a control room start, stop and check systems without sending someone into the dust.

How we deliver

From enquiry to a working system

01

Share the problem

Send photographs, a layout or a short description of where the dust comes from.

02

Site study

We review each source, the material, water and power available, and any moisture limits.

03

Design and quote

You receive a layout, equipment list and price for the system that fits.

04

Install and support

We supply, install and commission, train your operators and stay available for service.

Ready to get started? Let’s discuss your project.

Send photos or a layout of the dust source. An engineer will recommend a system and send a budget price.

FAQ

Frequently asked questions

Have a different question? Ask our engineers.

What is an automated dust suppression system?

A system whose pumps and valves are controlled by sensors and a PLC so that spraying starts and stops according to plant activity, weather or measured dust.

Can sensors measure dust and trigger the system?

Yes. A particulate monitor can start selected zones when dust concentration passes a set point. It is usually combined with activity triggers.

Can an existing manual system be automated?

In most cases, by adding solenoid or actuated valves, sensors and a control panel to the existing pump and piping.

Does automation save water?

Yes. Running only when dust is generated is the single most effective way to cut water and compressed air use.

Get a recommendation

Tell us where the dust is. We will tell you what fits.

Send the basics and an engineer will come back with a recommendation and a budget price.

  • No-obligation budgetary proposal
  • Design matched to your material and site
  • Supply, installation and service