Skip to content
Chennai · Nagpur · GurugramService locationsFAQs
Dust Suppression Systems Co homeGet a quote
Applications · Hoppers & unloading

Hopper, wagon tippler and truck unloading dust suppression

When a truck, wagon or grab tips into a hopper, the falling material pushes a burst of dusty air back out. Hopper dust suppression captures that burst in the few seconds it lasts.

Coal handling plant conveyors and stockyard
CoversTruck tipping, wagon tipplers, grab hoppers, loading spouts
MethodDry fog ring, fog curtain, partial enclosure
TriggerVehicle or tippler position sensor
MoistureVery low addition to the material
The problem

Why unloading points are so dusty

A tonne of falling material displaces close to its own volume of air. That air leaves the hopper carrying the finest dust with it, straight into the operator's breathing zone.

  • Short, intense dust bursts that general yard spraying cannot catch
  • Open hoppers exposed to cross-wind
  • High tipping rates leaving no time for dust to settle
  • Material that must not be wetted before the next process
Our approach

How we treat unloading points

The approach is always to contain first, then suppress what escapes.

Dry fog ring around the hopper

Air-atomising nozzles around the hopper mouth create a fog blanket that the rising dust has to pass through.

Dry fog system

Fog curtains across openings

A curtain of fine mist across the tipping side holds dust inside the hopper enclosure.

Fog curtain

Loading point extraction

At truck and wagon loading spouts, a dedusting connection draws displaced air through a filter.

Dedusting systems

Sheds, wind and timing

Side walls or a three-sided shed around a tipping hopper make any fog system far more effective, because the fog stays where the dust is. Controls start the fog a moment before the tip and keep it running for a short time afterwards, so water and air are used only during the event.

How we deliver

From enquiry to a working system

01

Share the problem

Send photographs, a layout or a short description of where the dust comes from.

02

Site study

We review each source, the material, water and power available, and any moisture limits.

03

Design and quote

You receive a layout, equipment list and price for the system that fits.

04

Install and support

We supply, install and commission, train your operators and stay available for service.

Keep exploring

Related systems and applications

Ready to get started? Let’s discuss your project.

Send photos or a layout of the dust source. An engineer will recommend a system and send a budget price.

FAQ

Frequently asked questions

Have a different question? Ask our engineers.

How do you control dust at a truck unloading hopper?

Partly enclose the hopper, fit a dry fog ring around the mouth, and trigger it from a vehicle sensor so it runs during each tip.

What is used for dust suppression at a wagon tippler?

Dry fog or fine mist headers along the tippler and hopper, interlocked with the tippler rotation so they operate through the unloading cycle.

Will fog at the hopper wet the material?

Dry fog adds very little moisture, which is why it is used ahead of crushers, screens and bunkers that block with wet material.

Can you treat mobile or grab-fed hoppers?

Yes. Fog rings can be fitted to mobile and port eco-hoppers with their own small pump and air supply.

Get a recommendation

Tell us where the dust is. We will tell you what fits.

Send the basics and an engineer will come back with a recommendation and a budget price.

  • No-obligation budgetary proposal
  • Design matched to your material and site
  • Supply, installation and service