Skip to content
Chennai · Nagpur · GurugramService locationsFAQs
Dust Suppression Systems Co homeGet a quote
Applications · Conveyors & transfer points

Conveyor and transfer point dust suppression

Most conveyor dust is released at transfer points, where material falls from one belt to the next. A conveyor dust suppression system treats those points and leaves the rest of the belt dry.

Conveyor system dust control
TreatsHead and tail ends, transfer chutes, discharge points
MethodsDry fog, fine spray, sealing and skirting
InterlockRuns only with belt running and loaded
MoistureLow, to avoid belt slip and chute blockage
The problem

Where conveyors release dust

Along a covered belt run very little dust escapes. The trouble is concentrated at a few points.

  • Material free-falling through transfer chutes and dragging air with it
  • Impact at the loading zone of the receiving belt
  • Carry-back dropping from the return belt
  • Gaps in skirt boards and chute seals
  • Open discharge onto stockpiles or into bunkers
Our approach

How we control conveyor dust

Suppression works best alongside good mechanical containment.

Dry fog at transfer chutes

Nozzles inside the chute enclosure fill it with fog so dust agglomerates and falls back onto the belt.

Dry fog system

Fine spray at the loading zone

A light spray on the material stream at the receiving belt damps the surface fines.

Water spray system

Dedusting on enclosed transfers

Where material must stay dry, the transfer is hooded and connected to a filter.

Dedusting systems

Containment comes first

Before adding nozzles we look at the transfer itself: chute geometry, skirt board condition, a settling zone after the loading point and a belt cleaner at the head pulley. Fixing leaks there can halve the amount of fog needed.

How we deliver

From enquiry to a working system

01

Share the problem

Send photographs, a layout or a short description of where the dust comes from.

02

Site study

We review each source, the material, water and power available, and any moisture limits.

03

Design and quote

You receive a layout, equipment list and price for the system that fits.

04

Install and support

We supply, install and commission, train your operators and stay available for service.

Keep exploring

Related systems and applications

Ready to get started? Let’s discuss your project.

Send photos or a layout of the dust source. An engineer will recommend a system and send a budget price.

FAQ

Frequently asked questions

Have a different question? Ask our engineers.

How do you suppress dust on a conveyor belt?

Treat the transfer points: seal the chute and skirting, add dry fog or fine spray inside the enclosure, and interlock it with the belt so it runs only when material is flowing.

Will water spray cause belt slip or blocked chutes?

It can if too much is used. Dry fog and correctly sized fine spray add very little moisture, and the belt interlock prevents spraying an empty belt.

How many nozzles does a transfer point need?

It depends on chute size, belt width, tonnage and drop height. A typical transfer uses a small group of nozzles at the discharge and at the loading zone.

Can the system be fitted without stopping the plant?

Nozzle headers and piping are installed alongside the running belt; only the final tie-ins need a short stoppage.

Get a recommendation

Tell us where the dust is. We will tell you what fits.

Send the basics and an engineer will come back with a recommendation and a budget price.

  • No-obligation budgetary proposal
  • Design matched to your material and site
  • Supply, installation and service